以前のリビジョンの文書です


ネットワーク設定(1)

IP関連設定

DHCPで設定

# vi /etc/dhcp/dhclient.conf
----
send dhcp-client-identifier=hardware;  (こちらは必須・スペースなし)
# vi /etc/dhcpcd.conf
----
  send dhcp-client-identifier = hardware;  (こちらは必須ではないみたい)
  interface eth0
  interface wlan0
# vi /etc/network/interfaces
----
  iface eth0 inet manual
  # iface eth0 inet dhcp  (この行をmanualにしないとDHCPでアドレスが設定できない?)
  
  allow-hotplug wlan0
  iface wlan0 inet manual
  # iface wlan0 inet dhcp

固定アドレスで設定

アドレスを固定にする場合

# vi /etc/dhcpcd.conf
----
send dhcp-client-identifier = hardware;  (こちらは必須ではないみたい)
interface eth0
static ip_address=192.168.1.152/24
static routers=192.168.1.30
static domain_name_servers=192.168.1.1

interface wlan0
static ip_address=192.168.1.162/24
static routers=192.168.1.1
static domain_name_servers=192.168.1.1
# vi /etc/network/interfaces
----
iface wlan0 inet manual
iface eth1 inet manual

“/etc/network/interfaces” ファイルでは設定できない
(参考) https://hirooka.pro/?p=8526


WLAN

# cd /etc/wpa_supplicant
# vi wpa_supplicant.conf
----
wpa_supplicant.conf
# wpa_passphrase BBUser870201 XXXXXXXXXXXXXXXXXXX
# sudo vi /etc/wpa_supplicant/wpa_supplicant.conf
----
 network={
      ssid="BBUser870201"
      psk=xxxxxxxxxxx....................xxxxx
      proto=RSN
      key_mgmt=WPA-PSK
      pairwise=CCMP
      auth_alg=OPEN
 }
# chmod 600 wpa_supplicant.conf
# ifconfig wlan0 down
# ifconfig wlan0 up
# ifconfig wlan0
# vi /etc/modprobe.d/8192cu.conf
----
# Disable power saving
options 8192cu rtw_power_mgnt=0 rtw_enusbss=1 rtw_ips_mode=1

DNSサーバ指定

# vi /etc/resolv.conf
----
  nameserver 8.8.8.8 (DNSサーバのIPアドレス)
# sudo /etc/init.d/networking reload  (設定反映)
raspberry_pi/0020network.1499324328.txt.gz · 最終更新: 2017/07/06 06:58 by admin
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0